5 Mistakes to Avoid when Getting the Chip Seal Process Done

The ideal way to help any paved surface maintain its condition and allow it to last longer may be by relying on chip seal contractors in Fredericksburg TX to assist you. One of the common techniques that you may be interested in having done to your parking lot or driveway involves the chip seal process. This can be completed within a reasonable amount of time and is very affordable. You will want to rely on a professional that has the expertise to do the job right. Being aware of some mistakes that may occur when having this done is sure to be helpful to you regardless if you’re a business or residential owner.

Mistake #1: Temperature too cool

It’s important for this entire process to be done when the weather is warmer outside. In fact, there are certain temperatures that should be in place before your chip seal contractors in Fredericksburg TX will complete this job.

If it’s too cool outside the chip seal process may not work as well as it should. However, the summer months may allow you to get the result that you want for your parking lot or driveway to look its best.

Mistake #2: Failure to control traffic

Once the chip seal process has been complete, you will want to take the time to monitor the traffic as much as you can. It's a very good idea to plan beforehand for this and consider during the work after business hours if you’re doing a parking lot.

This will enable the chip seal to cure properly and could be the key to getting the results that you want. Regardless if you’re using this technique for your parking lot or driveway, you will want to allow at least 24 hours for this area to be left untraveled if all possible.

However, after this amount of time has passed it’s fine to allow others to drive on the asphalt area. Be sure to control traffic as much as possible when hiring chip seal contractors in Fredericksburg TX to assist you.

Mistake #3: Rainy weather

Although it’s impossible to predict the weather, you should take the time to view the forecast before scheduling this job. You will want to ensure that it’s supposed to be sunny or at least partly cloudy before working with any chip seal contractors in your area.

It's too risky and challenging to attempt to do this work when it’s raining outside, and you simply can run into some problems if this happens. Taking the time to tune into your local weather channel is sure to be the time that is well-spent!

Mistake #4: Not setting properly

In order to get the best results when working with chip seal contractors in Fredericksburg TX, you will want the mixture of asphalt and water to properly set before putting the gravel on top of it. Of course, when you hire the right expert to do this job for you, there shouldn’t be any problems with this.

However, it will take precision when mixing the asphalt with the water in order to allow the mixture to set correctly. The good news is the professional you hire to do this job for you has the expertise to get it done accurately.

Mistake #5: Chips were dirty

It’s important when spreading the chips (gravel) on top of the asphalt mixture that these are clean. Your contractors in Fredericksburg TX will want to be sure there is less than 0.75 dust ratio on the chips before putting these down during the chip seal process.

This is typically done well in advance by the gravel company but is something that your contractor will want to check before using the spreader equipment.

The key to having the best job done when working to improve your parking lot or driveway area will rest in hiring chip seal contractors in Fredericksburg TX that are licensed and bonded. This can reduce the possibility of unwanted mistakes being made that could cause your chip seal process to go badly. Be sure to do the right amount of research before hiring any professional to do this type of work for you!